Primary Navigation

Dent Repair Plastic Bumper

Dent Repair Plastic Bumper

Can you fix a dent in a plastic bumper?

Replacement bumper covers can cost more than $1,000. But dents in the soft plastic bumper covers on cars and SUVs can often be smoothed out at home by applying heat and a little elbow grease. It takes a bit of patience, and certainly experience helps.[1]

How much does it cost to fix a dent in a plastic bumper?

If you just need to have the dent pulled back out and into place, the repair will likely cost $50-$100. However, if the dent is very deep and the paint was damaged as well, you could be looking at a repair of around $200-$1,000, depending on the dent and your chosen repair shop.[2]

Can a bent plastic bumper be repaired?

If you’d prefer to let the professionals handle it, body repair shops are well-accustomed to handling bent plastic bumpers. They use a process called bumper reshaping. This is a time-consuming process that requires heating, cooling, and applying force to re-form the shape.[3]

Do dent pullers work?

Do they work? Dent pullers only work on shallow dents that are positioned on a flat, flexible surface. They can improve the appearance of car dents but are unlikely to create a perfect finish. Unfortunately, DIY dent pullers will not work on deep, angular dents or damage along the edges of bodywork.[4]

Can a body shop fix a bent bumper?

Damages that Require Replacement However, if all the connectors on your bumper are in place and intact, then your auto body shop may be able to fix the alignment or reattach it. This requires the bumper to still be in otherwise good condition.[5]

Is it cheaper to repair or replace a bumper?

Bumper repair can be performed in-shop and is often cheaper than bumper replacement. Bumper repair normally costs between $100 and $1,000.[6]

How much does it cost to fix a dented front bumper?

Larger dent: $200-$600 If the dent is larger, the price will go up. Crack or hole: $300-$450 If your bumper is cracked or has a hole, depending upon its severity, it may be repaired by putting plastic filler in the crack (and then sanding and painting).[7]

Does boiling water remove dents in cars?

Use boiling water Don’t just limit your use of boiling water for cooking and sanitary purposes. It can also be used to potentially remove unwanted depressions in your vehicle, that is, as long as you have a plastic bumper and are successfully able to access the dent from the backside.[8]

How do you get a dent out of a bumper with a plunger?

Put the plunger over the indented area and pull straight out. Your dent should pop right out. If you’re working on a bumper, you can also reach behind the dented surface to push the dent out. Repeat as needed until the dented area is flattened out.[9]

How do I get a dent out of my bumper?

Use boiling water. Boil a pot of water and pour it on the area with the dent, and then reach behind the bumper and push until the dent pops out. You can then pour cold water over the spot to cool and set the plastic.[10]

How do you pop out a dent?

First, heat the dent with the hairdryer approximately six inches away for about 30 seconds. Then cover the dent with a piece of aluminum foil and rub dry ice over it. The rapid change from hot to cold should make the dent pop out within a minute or so. Another temperature trick involves boiling water.[11]

How do you push out a dent?

If your dent is in a plastic surface like a front or rear bumper cover and you can get to its inside surface, you can pour boiling water over the area to soften it up, then push the dent out from the inside. If you can’t access the dent from the inside, try using a hair dryer to warm up and expand the outer surface.[12]

Leave a Reply

Your email address will not be published. Required fields are marked *