Primary Navigation

Learn Paintless Dent Repair Training

Learn Paintless Dent Repair Training

Can you DIY paintless dent repair?

Easy Ways to DIY Paintless Dent Repair Apply a bit of water to both the car and the plunger and place the opening of it around the circumference of the dent. Push and pull the plunger until the dent pops out and you’re good to go! Pro Tip: Make sure to only use this method on small to medium-sized dents.[1]

How much do PDR techs make in Australia?

However, considering repeat clients and the odd customers who want their cars ‘clean’ of dents (cars are the second most important commodity in Australia), and further referrals for a good PDR technician, the numbers start adding up to that figure of $250k per year.[2]

What PDR tools do I need?

PDR Tabs. There’s a whole variety of different tabs you get but the different tabs have different shapes ,different designs and colors. Dent Lifter. Glue Removing Agent. Glass Window Protector Board. Hook Bar (Different Lengths). Ratchet Handle Tools.[3]

Will boiling water get a dent out of car?

Use boiling water Don’t just limit your use of boiling water for cooking and sanitary purposes. It can also be used to potentially remove unwanted depressions in your vehicle, that is, as long as you have a plastic bumper and are successfully able to access the dent from the backside.[4]

How effective is paintless dent removal?

Since paintless dent repair can remove 80-90% of dents, it is the best way to get a dent out of your car. If we can access the area behind the dent, we can often massage out the dent with the Paintless Dent Repair process.[5]

Do dent pullers work on hail damage?

Experts say that between 80% to 90% of hail dents can be repaired using paintless dent repair (PDR) techniques. Because the possible damage caused by hail can vary so widely, using paintless techniques is one of the best ways to restore your car’s panels to the original condition.[6]

Will a plunger remove a car dent?

Put the plunger over the indented area and pull straight out. Your dent should pop right out. If you’re working on a bumper, you can also reach behind the dented surface to push the dent out. Repeat as needed until the dented area is flattened out.[7]

What does pouring boiling water on a car do?

Not only does using hot water to de-ice a vehicle result in cracks on the windshield, but it can also damage paintwork when the boiling water melts off protective wax and leaves a white watermark stain, according to Prestone.[8]

How much does it cost to pop out a dent?

The dent repair cost may range from $50 to $2,500. Although that’s a broad range, most small dents that are roughly an inch in size may cost around $50 to $125. Small indentations may come from a flying rock or piece of hail. Dents stemming from a collision are typically larger and cost $150 or more.[9]

Is fixing car door dents worth it?

Unless the dent or scrape is very minor (and therefore very cheap to fix), older and less-valuable vehicles probably won’t gain much value from a repair. You’re often better off just keeping your money and living with the scrape and the knowledge that your car is a little less perfect than it was yesterday.[10]

How does dry ice remove hail dents?

Park your car with the dent in the sun and let the dent and surrounding sheet metal warm up. Then, wearing protective gloves, put a small block of dry ice over the dent. The rapid chilling of the metal will “pop” the dent without scratching the paint.[11]

Will heat pop out hail dents?

Parking your vehicle for just one week in the hot sun may eliminate up to 90 percent of the dents caused by hail. If you’re a do-it-yourselfer, there are also a couple of other remedies for getting rid of those dents. Applying a hair dryer to the dent will have much the same effect as sunlight.[12]



Leave a Reply

Your email address will not be published.