Primary Navigation

slide hammer dent repair

Slide Hammer Dent Repair

Can you hammer out a dent?

Hammering out the damage requires access to both sides of the dent: the underside and the outer surface. To get to the back of the dented metal, you need to remove door panels or fenders. You’ll hammer against the dolly, as it stabilizes the taps made inside the dented surface from the outside of the sheet metal.[1]

What does a slide hammer do?

Slide hammers can be attached to objects in multiple ways including screw threads, hooks, and others. Slide hammers are typically used in automotive repair to pull dents, remove bearings or other parts, and when an object needs to be struck from an inaccessible side.[2]

Do suction cup dent pullers work?

They can improve the appearance of dents but probably won’t create a perfect finish. But these tools will not work on deep, angular dents or damage along the edges of bodywork. Dents in areas of thick metal will also be very difficult to remove at home.[3]

Do you need a slide hammer?

Slide hammers don’t see much use, but when they come out of the toolbox, it’s usually for an important mission. They’re great for pulling dents, popping out stuck axles, or popping a bearing off its hub.[4]

What is a slide hammer made of?

A slide hammer is made from a long steel rod with a replaceable hook or screw-tip on one end and a handle on the other, with a steel ring welded to the rod at the handle end.[5]

Does boiling water remove dents in metal?

Unfortunately, this technique can be used only on plastics, which can be reshaped by using heat. Metal does not respond in the same way to heat as plastic does. So, do NOT attempt to fix metal dents with boiling hot water.[6]

Can you plunge a dent out of a car?

You’ll need a pot of very hot water and a simple plunger. Pour the hot water over the dented surface of the car. This softens the material. Put the plunger over the indented area and pull straight out.[7]

Is it worth fixing small dent on car?

Unless the dent or scrape is very minor (and therefore very cheap to fix), older and less-valuable vehicles probably won’t gain much value from a repair. You’re often better off just keeping your money and living with the scrape and the knowledge that your car is a little less perfect than it was yesterday.[8]

Does DIY dent removal work?

They can improve the appearance of car dents but are unlikely to create a perfect finish. Unfortunately, DIY dent pullers will not work on deep, angular dents or damage along the edges of bodywork. Dents in areas of thick metal are very difficult to remove at home.[9]

Will boiling water damage car paint?

It could warp the metal out of shape, make it less sturdy; it could even ruin your paint job if your paint isn’t up to par.[10]

How do I get a big dent out of my car?

Try the plunger method. You know how powerful a plunger can be with your plumbing problems? Use hot water for dented bumpers. Bumper plastic is hard for good reason. Hammer out the dent. Pop out the dent with a hair dryer and compressed air. Buy a dent removal kit.[11]

How do you Undent metal?

Heat and Cold First, try heating the dented area with a heat gun or hair dryer for several minutes. Keep the heat source moving so the surface heats even-ly. Frequently, this alone is enough to remove the dent. If it isn’t, immediately apply something very cold to the dent while it’s still hot.[12]



Leave a Reply

Your email address will not be published. Required fields are marked *