Primary Navigation

Wheel Well Dent Repair

Wheel Well Dent Repair

How do you pop a dent out of a metal fender?

Start by cleaning your car fender to improve the suction cup’s grip. Position the cup over the dent, push the tool as far down as it will go, then pull it straight out. The motion should yank the dent out. For best results, use a brand new suction cup with an easy-to-grip pulling handle.[1]

Do dent pullers work?

Do they work? Dent pullers only work on shallow dents that are positioned on a flat, flexible surface. They can improve the appearance of car dents but are unlikely to create a perfect finish. Unfortunately, DIY dent pullers will not work on deep, angular dents or damage along the edges of bodywork.[2]

How do you pop out a dent?

First, heat the dent with the hairdryer approximately six inches away for about 30 seconds. Then cover the dent with a piece of aluminum foil and rub dry ice over it. The rapid change from hot to cold should make the dent pop out within a minute or so. Another temperature trick involves boiling water.[3]

How much does it cost to fix a dent in a fender?

Door/Fender Dents and Dings Expect to pay between $50 to $150. If the paint isn’t missing or, if there aren’t any cracks, Paintless Dent Repair (PDR) can keep costs down.[4]

Can a dented fender be fixed?

If your fender has sustained a dent from a collision or something else coming into contact with it, if the paint is intact, it can probably be repaired with the PDR process. There are some instances where your fender may not be able to be repaired with PDR.[5]

How do you Undent metal?

Heat and Cold First, try heating the dented area with a heat gun or hair dryer for several minutes. Keep the heat source moving so the surface heats even-ly. Frequently, this alone is enough to remove the dent. If it isn’t, immediately apply something very cold to the dent while it’s still hot.[6]

How do you get a dent out of a car with hot water?

Use boiling water Simply boil water in a teapot, protect yourself from burns with rubber gloves, and have a pot of cold water on hand. Then, pour the hot water from the teapot over the dent. Before it cools down, pop the dent out from the inside.[7]

How do you get a sharp dent out of a car?

Heat the affected area with your dryer, heat gun, or hot water. Less severe dents may pop out on their own with the application of enough heat. If the dent won’t pop out, use a suction cup or rubber mallet to pull or gently hammer the dent out.[8]

Do suction cups work for dents?

These work by attaching to your car with suction, allowing you to pull dents and dings out. They work very much same way as a toilet plunger.[9]

Do plungers work on car dents?

Put the plunger over the indented area and pull straight out. Your dent should pop right out. If you’re working on a bumper, you can also reach behind the dented surface to push the dent out. Repeat as needed until the dented area is flattened out.[10]

Will boiling water damage car paint?

It could warp the metal out of shape, make it less sturdy; it could even ruin your paint job if your paint isn’t up to par.[11]

Does a hair dryer remove dents?

To remove a dent in a car with a hair dryer, start by applying heat to the dent with a dryer held 5-7 inches away from the car. Then, place a sheet of aluminum foil over the dent, and put on a pair of thick rubber gloves. Pick up a piece of dry ice and rub it over the dented area for 30-50 seconds.[12]



Leave a Reply

Your email address will not be published.